Warrior Dampcoat
Warrior Dampcoat
Back to Warrior Acrylic Primers and Sealers
Warrior Dampcoat is a synthetic co-polymer based pigmented coating with excellent resistance to moisture, alkali and UV light. It allows the breathing out of water vapour, yet prevents excessive moisture penetration from the exterior. It is also mould resistant.
USES :
Warrior Dampcoat is a white pigmented coating which may be used on the following suitably prepared surfaces:
- Distempered surfaces
- Raw plaster
- Flaky or chalky walls
- Fibre Cement and, Masonry surfaces
- Bricks
SPECIFICATION OR RECOMMENDED PAINT SYSTEM :
NEW WORK:
Primer: Warrior Alkali Resistant Primer
Finishing: 2 coats of Warrior Dampcoat
PROPERTIES :
APPLICATION: Brush, Roller and Spray*
CLEANING SOLVENT: Mineral Turpentine
THINNING SOLVENT Mineral Turpentine
SPREADING RATE:
- PRIMER COAT : 6-8m² per litre
- FINAL COAT : 8-10m² per litre (depending on porosity and surface condition)
DRYING TIMES:
- SURFACE DRY : 1-2 hours
- HARD DRY : 6-8 hours
- OVERCOATING : 6-8 hours
PACK SIZE: 1L, 5L
COLOUR RANGE: White (Pastel on request)
SPECIFIC GRAVITY: 1,25 + 0,05 kg per litre
VISCOSITY: 75-80 KU
FLASH POINT: >35°C
FINISH: Matt
GENERAL INFORMATION :
*For spray application consult our Technical Department.
It is important that this product be thoroughly mixed with a flat paddle before use.
Contact us for the Warrior Dampcoat.