Warrior Quick Drying (QD) Enamels
Warrior Quick Drying Enamel
Back to Warrior Industrial Paints
Warrior Quick Drying Enamel is a styrenated alkyd based industrial spraying enamel, which dries to a gloss finish.
USES :
Warrior Quick Drying Enamels can be used as a finishing coat on suitably primed metal substrates. It is suitable for interior or exterior use.
SPECIFICATION OR RECOMMENDED PAINT SYSTEM :
Steel surfaces : Apply one coat of Warrior QD Red Oxide Primer to cleaned steel and allow to dry for 4 hours. Thereafter finish off with 2 coats of Warrior QD Enamel allowing 4 hours drying time between coats.
PROPERTIES :
APPLICATION: Conventional Spray
CLEANING SOLVENT: E-Thinners
THINNING SOLVENT: E-Thinners
SPREADING RATE:
- PRIMER COAT : N/A
- FINAL COAT : 8 m² per litre
DRYING TIMES:
- SURFACE DRY : 30 minutes
- HARD DRY: 3-4 hours
- OVERCOATING : 4 hours
PACK SIZE: 1L, 5L, 25L
COLOUR RANGE: White, black and a range of standard colours
SPECIFIC GRAVITY: 1,00 + 0,05 kg per litre
VISCOSITY: 80-100 seconds F4
FLASH POINT: 9°C
FINISH: Gloss
GENERAL INFORMATION :
- This product must not be applied over White Spirits/Alkyd base paints.
- This product is recommended for spray application. Due to its quick drying nature only small areas may be brushed.
c) It is important that this product be thoroughly mixed with a flat paddle before use.
Contact us for the Warrior Quick Drying Enamel.