Warrior Wave-Coat
WARRIOR WAVE-COAT
Back to Acrylic Based Paints
Warrior Wave-Coat is a durable semi-sheen acrylic paint with a smooth ripple type finish.
USES :
Warrior Wave-coat is suitable for interior or exterior walls with slight imperfections such as rough plaster, pock marks, shutter lines, etc. It eliminates the necessity to re-plaster
SPECIFICATION OR RECOMMENDED PAINT SYSTEM :
SURFACE PREPARATION:
a) New plaster, cement renderings and concrete : Brush down or scrape to remove all plaster or hard mortar splashes and other surface contamination. Ensure surface is dry or properly cured. Make good any cracks and repair any defects to match porosity and profile of surrounding areas.
b) Previously painted masonry surfaces : Scrape or brush down to remove all loose and flaking paint or strip back if necessary to a firm base. Make good all cracks and surface defects. Loose and powdered surfaces should be brushed down with a stiff fibre brush and sealed with Warrior Alkali Resistant Plaster Primer.
FINISHING:
a) Apply one coat of Warrior Alkali Resistant Plaster Primer to masonry surface areas and allow to dry.
b) Finish with two coats of Warrior Wave-Coat allowing 12-24 hours in between coats.
PROPERTIES :
APPLICATION:
- Sheepskin Roller or Broad
- brush with polyurethane
- foam roller to finish
CLEANING SOLVENT: Water
THINNING SOLVENT: Not recommended
SPREADING RATE:
- PRIMER COAT : Spreading rate will be determined by the technique used on application
DRYING TIMES:
- TOUCH DRY : 4 hours
- HARD DRY : 12 hours
- OVERCOATING : overnight
PACK SIZE: 5L, 20L
COLOUR: Off White only (colours on request)
VISCOSITY: 130-140 KU
FLASH POINT: Non flammable
RELATIVE DENSITY 1,45 + 0,05 kg per litre
FINISH: Low sheen
GENERAL INFORMATION :
- This product should not be thinned as it is supplied ready for use.
- It is important that this product be thoroughly mixed with a flat paddle before use.
Contact us for the Warrior Wave-Coat Paint